I broke out a 8" x 8" by 2" piece of maple that probably originated from Allen Levine's scrap pile. I attached a faceplace, rounded it out on the bandsaw and then started on the outside profile. I got the outside profile shaped, sanded and finished after a while. I need to get somesanding tools it I'm going to do very much of this sort of work. . . I need to dig back into the archives - Vaughn has posted the tools he uses to polish his bowls.
I then chucked it up in the lathe chuck and started hollowing. I need to get some lessons . . . I ended up pretty much scraping the entire interior of the bowl at I couldn't figure out how to use the bowl gouge . . . Next stop Youtube . . .
I was getting there when I realized that it had hollowed too deep and the bottom was paper thin. I attempted to continue but a catch on the rim shattered the bowl and ended this project.
I have 3 pic attached :
One showing the outside of the bowl - sans bottom,
Another showing the inside of the bowl pieces.
3rd image showing the cross section I had at blastoff.
Cheers
Jim
Source: http://familywoodworking.org/forums/showthread.php?26806-This-project-went-well-for-a-while-at-least
chris cook nest williams syndrome jay leno lindsey lohan reed hastings hpv vaccine
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.